Jump to content


VPN Routing visibiity in Control Network GUI

vpn routing network

2 replies to this topic

#1 Adrian Tschopp

Adrian Tschopp
  • Members
  • 24 posts

Posted 14 January 2013 - 06:48 AM

The VPN Routing is visualized in Control Network GUI quite well. But last weekend I found a wrong entry in VPN Routing but I had now way to see from which tunnel the entry came. So I had to check the configuration of all VPN tunnels in GTI. A nightmare in a GTI with many tunnels...

My request is to have the tunnel name displayed along with each VPN Routing entry similar to the names found in main and default routing tables.


#2 Manuel Huber

Manuel Huber
  • Members
  • 35 posts

Posted 14 January 2013 - 07:10 AM


Up to version 5.2.3 there was at least the VPN-interface shown for each routing table entry, so if you had different interface names (vpn0, vpn1 etc.) for each tunnel it was easy to figure out the according tunnel.
Unfortunately this information is missing since 5.2.4.
I mentioned this as a bug but not sure if there is any attempt to fix this.

#3 Teemu Schaabl

Teemu Schaabl
  • Members
  • 40 posts

Posted 22 January 2013 - 03:58 AM


I refer to ktinctrl when trying to find my way around in complex setups. The Information is there, so it should be a problem using it in "Control / Netwwrks"


Reply to this topic