We have a 620 model IM Appliance running firmware version 4.2.01.004. On the dashboard, the firmware storage shows as 90% full. The usage has increased 2% within the past month. On the Barraucda Support site, it says to contact support. Upon doing so, I was informed that the product is no longer supported and that they could not help me. I'm seeking any information about options for resolving this issue before the storage device fills up and the device crashes. Thanks in advance for any and all help!
Firmware Storage Almost Full - IM Firewall Appliance
Posted 11 August 2015 - 01:14 PM
Just a thought since I went through a similiar issue due to a bug in our X400 firewall.
Could you save off the configuration, then restore to factory state ( you have to interrupt the boot process ) which re-installs the O.S. from firmware effectively wiping the drive partitions?
Then make sure you bring the unit up to the same firmware release level as your configuration file if it is not already there, and restore your config.