Jump to content


Photo

BN F800 to original factory settings? Don't remember interface.

F800 NG Firewall ART reboot factory setting

This topic has been archived. This means that you cannot reply to this topic.
2 replies to this topic

#1 Jonathan Klein

Jonathan Klein
  • Members
  • 34 posts

Posted 01 April 2015 - 10:36 AM

I made a mistake while configuring my BN F800 NG Firewall. I need to reset the NG firewall to its original factory settings to configure it from scratch. I can console into the F800 with my SSH client and get into ART.

 

What do I need to do to execute a complete back to the F800's original settings before I started configuring it?

 

Jonathan



#2 Stefan Hora

Stefan Hora
  • Barracuda Guru
  • 153 posts

Posted 01 April 2015 - 11:38 AM

I don't know if there is a command, but the quickest way is to power off, attach the USB-Stick, Power on, go for a coffee and if the display shows "system down" then take the USB Stick off and power off/on.

Should take around 5 Minutes.

 

This will repartition/reformat the disk and install the software from the stick with factory settings.

 

Except if you have a *,par File on the stick. Then it will try to load that config.



#3 Michael Zoller

Michael Zoller
  • Barracuda Team Members
  • 209 posts

Posted 02 April 2015 - 01:54 AM

Nothing to add to what Stefan wrote, except if you never did this before here is the Techlib link describing a USB key recovery: https://techlib.barr...G60/USBRecovery