Jump to content


Photo

Interfaces/IPs state off after soft activation of direct attached routes

vlan network routing direct attached route state Interfaces/IPs fibre port additional IPs Trusted uplink

  • Please log in to reply
1 reply to this topic

#1 Jonathan Klein

Jonathan Klein
  • Members
  • 34 posts

Posted 13 May 2015 - 10:00 AM

I just configured direct attached routes on my BN NG F800 for 7 vlans on fibre port b1. I added the .1 IP Addresses as their default gateways in the Additional IP addresses under Server properties.

 

After successfully executing a soft network activation, the port b1 light was not up. Port b1 for the F800 runs to te1/1/2 of an HP A5120 switch. I checked the Network Tab of the F800. In the Interfaces/IP section, I see that the state is off for the direct attached routes (all are Trusted).

 

Is there anything additional or different that I need to do?



#2 Jonathan Klein

Jonathan Klein
  • Members
  • 34 posts

Posted 13 May 2015 - 05:26 PM

Nevermind....fixed. SFP+ issue.