Jump to content


Photo

LACP Barracuda F600 between Force10 MXL 10/40Gb

lacp etherchannel switch dell cisco barracuda firewall aggregation

This topic has been archived. This means that you cannot reply to this topic.
1 reply to this topic

#1 Mikael Lelouch

Mikael Lelouch
  • Members
  • 1 posts

Posted 03 June 2015 - 02:09 PM

Hello everybody,
 
we have a problem of lacp between Dell Force10 MXL switches F600 and a barracuda. When we create a lacp active or passive mode and you try to disconnect and reconnect several times, at one time the ports are off. To switch ports must realize the "shutdown" and then "no shutdown" for return to the UP state physical ports. This problem is locate only two ports p11 and p12 firewall when you realize a bond4 with Mode 2 Barracuda side and the side Dell configuration is active LACP Mode
Do you have any tips or best practices for the configuration of a standard lacp Dell and Barracuda?

 

firmware  barracuda : 6.1.0

firmware dell force10 MXL : 9.7.0

 

Thank you

 

Best Regards,



#2 Matthias Maschler

Matthias Maschler
  • Barracuda Team Members
  • 107 posts

Posted 09 June 2015 - 05:24 AM

Hi Mikael,

 

I suggest to contact Barracuda Technical Support to get your issue solved. Our engineers can have a look at your configuration and investigate what's going on.

Thanks,

Matthias